Runco REFLECTION Especificações descarregar pdf (Página 34)

Installation

22 Runco RS-1100 Series Owner’s Operating Manual

PRE

IMINAR

Remove Projector Front

Feet

Place the projector upside down on a blanket

or other soft surface. Then, remove the two

front feet by turning them counter-clockwise.

Install Anamorphic Lens

Motor

Line up the eight mounting holes on the lens motor housing with those on the bottom of

the projector. Secure the motor to the projector with the eight screws provided for this

purpose, as shown in

Figure 3-6.

Figure 3-6. RS-1100 Ultra with AutoScope Lens Motor – Bottom View

➤

The anamorphic lens mounting kit is partially pre-assembled at the

factory – the AutoScope lens motor and lens mounting assemblies

are both fully assembled.

DO NOT OVER-TIGHTEN THE SCREWS.

Note

Caution

Downloaded From projector-manual.com Runco Manuals

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 91 92

Sem comentários

Runco REFLECTION Especificações Página 34