Runco XtremeProjection X-200i Especificações descarregar pdf (Página 57)

Installation

Runco X-200i Series Installation/Operation Manual 41

PRE

IMINAR

Attach Lens Mounting Assembly to Lens Motor Carriage Plate:

1. Remove the two Yaw/X Adjustment Levers and Washers (8) from the bottom of the

Anamorphic Lens Holder (6).

2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or Fixed

CineWide Base Plate (7). Position the bracket so that the long slot at the bottom of

the lens holder is perpendicular to the corresponding slots on the plate.

3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers (9) and

Yaw/X Adjustment Levers that you removed in Step 1.

4. Use the Height/Y Adjustment T-Screws/Washers (4), Pitch Adjustment

T-Screws/Washers (5) and T-Nuts (1) to attach the Pitch Adjustment Yoke and Lens

Adapter Ring to the Anamorphic Lens Holder. The Yoke should be as close to the

primary lens as possible.

5. Attach the lens to the Lens Adapter Ring by threading it clockwise.

Figure 3-19. Attaching the Anamorphic Lens to the Lens Ring

Lens threads into ring

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 117 118

Sem comentários

Runco XtremeProjection X-200i Especificações Página 57